Autoreclose Success Judgement (Arc-Success); Final Trip Judgement (Arc-Ft); Reset; Autoreclosing Requirement - Toshiba GRE110 Instruction Manual

&
ARC-
S1
ARC-SHOT1
&
S2
ARC-SHOT2
&
S3
ARC-SHOT3
&
S4
ARC-SHOT4
&
S5
ARC-SHOT5

Autoreclose success judgement (ARC-SUCCESS)

If a re-trip does not occur within a set period of time after output of the autoreclosing shot, it is
judged to be an Autoreclose success(ARC-SUCCESS).
The period of time is selected by setting [TSUC] to "0.1-600.0s".

Final trip judgement (ARC-FT)

The following cases are judged ARC-FT(Final Trip) and autoreclose is reset without autoreclose
output.
• Autoreclose initiation when autoreclose initiation is not ready
• Autoreclose initiation after output of the final shot for the setting applied in the multi-shot
mode
• Autorecloce block signal
- Autoreclose block signal by programmable BI
- OC1 to OC4, EF1 to EF4 and SEF1 to SEF 4 trip of setting autoreclose block are active.
Setting [∗∗∗∗-INIT] = NA / On / Block
NA: Autoreclose initiation is not active.
On : Autoreclose initiation is active.
Block: Autoreclose is blocked.
• PLC signal ARC-S∗_COND is not completed. FT is performed after Timer [TR*].

Reset

If the CB CLOSE(CB close condition) signal is alive and the the CB is closed within a period of
time after an autoreclose initiation, the autoreclose is forcibly reset.
The period of time is selected by setting [TRSET] to "0.01-300.00s".
It is assumed that the CB is not open(=CBF), in spite of the trip output(=autoreclose initiation).
TD1
t 0
S
F/F
R 0.01-300.00s
PLC default setting
303 ARC-S1_COND
CONST1
TD2
t 0
S
F/F
0.01-300.00s
R
ARC-S2_COND
CONST1 304
TD3
t 0
S
F/F
0.01-300.00s
R
305 ARC-S3_COND
CONST1
TD4
t 0
S
F/F
R 0.01-300.00s
306 ARC-S4_COND
CONST1
TD5
0
S
F/F
0.01-300.00s
R
ARC-S5_COND
307
CONST1
Figure 2.13.3 Autoreclosing requirement
 58 
ARC-SHOT1
&
≥1
ARC-SHOT2
ARC-SHOT3
ARC-SHOT4
ARC-SHOT5
&
&
&
&
6 F 2 T 0 1 7 2
TW
ARC-SHOT
0.01-10.00s