To Enter Numerical Values; To Complete The Setting - Toshiba GRE110 Instruction Manual

To correct the entered character, do either of the following:
• Discard the character by selecting "←" and pressing the ENTER key and enter the new
character.
• Discard the whole entry by pressing the CANCEL key and restart the entry from the first.

To enter numerical values

When the screen shown below is displayed, perform setting as follows:
The number to the left of the cursor shows the current setting or default setting set at shipment. The
cursor can be moved to upper or lower lines within the screen by pressing the ▲ and ▼ keys. If
setting (change) is not required, skip the line with the ▲ and ▼ keys.
/ 4 T i m e /
T i m e 1
> T i m e 1
T i m e 2
O C
E F
S E F
N P S
• Move the cursor to a setting line.
• Press the
or key to set a desired value . The value is up or down by pressing the
key.
• Press the ENTER key to enter the value.
• After completing the setting on the screen, press the END key to return to the upper screen.
To correct the entered numerical value, do the following.
• If it is before pressing the ENTER key, press the CANCEL key and enter the new numerical
value.
• If it is after pressing the ENTER key, move the cursor to the correcting line by pressing the
▲ and ▼ keys and enter the new numerical value.
Note:If the CANCEL key is pressed after any entry is confirmed by pressing the ENTER key, all
the entries made so far on the screen concerned are canceled and screen returns to the upper one.

To complete the setting

Enter after making entries on each setting screen by pressing the ENTER key, the new settings are
not yet used for operation, though stored in the memory. To validate the new settings, take the
following steps.
• Press the END key to return to the upper screen. Repeat this until the confirmation screen
shown below is displayed. The confirmation screen is displayed just before returning to the "Set.
(change)" sub-menu.
S t a r t e r
_ s
2 . 0 s
2 . 0 s
2 . 0 0 A
0 . 6 0 A
0 . 2 0 0 A Not available for model 400 series.
0 . 4 0 A Not available for model 820 series.
 103 
6 F 2 T 0 1 7 2
or