5
03.04
5.2
Tool offset
5.2.1 Tool offset function and basic display
Machine manufacturer
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Tool offset data consist of data that describes the geometry, wear,
identification, tool type, and the assignment to parameter numbers.
The unit used for the dimensions of the tool is displayed.
The input field is highlighted.
If no tool management, e.g. Standard, ShopMill, ShopTurn is
available, the following window appears after selecting the
"Parameters" operating area:
Every offset number contains up to 25 parameters depending on the
tool type.
The number of parameters shown in the window is that for the tool
type.
The maximum number of offset parameters (T and D numbers) can
be set by means of machine data.
Please note information supplied by machine tool manufacturer!
Parameters Operating Area
5.2 Tool offset
5
5-131