Siemens SINUMERIK 840D Operator's Manual page 299

9
03.04
References
Machine
data
General
MD
Channel-
spec. MD
Axis-
specific MD
Drive confi-
guration
Drive
MD
Display
MD
FDD
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
userdef User-defined: The unit is defined by the user.
The abbreviation in the right-hand column indicates the activation
criterion for a machine data:
•
so = effective immediately
•
cf = via "MD set effective" softkey activation
•
re = Reset
•
po = POWER ON (NCK Power On Reset)
/IAD/Installation & Start-up Guide: 840D
/IAC/Installation & Start-up Guide: 810D
/IAF/Installation & Start-up Guide: FM-NC
Operating sequence
Pressing the "machine data" softkey changes the horizontal and
vertical softkey bars.
You can select the machine data area you want by pressing the
following softkeys:
• General machine data ($MN_),
• Channel-specific machine data ($MC_),
• Axis-specific machine data ($MA_).
In the "Drive configuration" menu you can find information about the
drive modules that were configured via the startup tool or change the
drive configuration.
Danger
Changes in the configuration data have a considerable influence on
the machine. Incorrect parameterization can endanger lives and
cause the destruction of the machine.
Drive-specific machine data ($MD_)
Operator panel front machine data ($MM_)
Machine data for the feed drive,
Start-Up Operating Area
9.2 Display machine data
9
9-299