Siemens SINUMERIK 840D Operator's Manual page 51

2
03.04
Enlarge
window
Decrease
window
Close
editor
Settings
Editor
settings
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
2.5 General operating sequences
If you press the "Enlarge window" softkey, the program where the
cursor is displayed over the whole screen.
If you press the "Decrease window" softkey, both editor windows are
displayed next to each other.
Close editor
The current program overview appears again when you activate the
"Close editor" softkey.
Changes are saved in the program immediately when the cursor
leaves the modified line.
Editor settings
You can define the following values in the "Editor Settings" window:
•
Enable a newly created program automatically when it is closed,
•
Skip the "Line feed",
See also Chapter 6: Selective Program Protection: RO
•
Display hidden lines (HD) in the program,
See also Chapter 6: Hidden program lines: display HD
•
Shorten positioning time within a large file (e.g. in mold making).
You can select a special procedure as well as specify file size up
to 58 KB.
Operating sequence
If you press the horizontal softkey "Settings"
and the vertical softkey "Editor settings" you get the following window:
Operator Components/Operating Sequences
2
2-51