Manage Magazine Locations - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.5 Tool management ShopTurn

5.5.12 Manage magazine locations

Disable magazine location If a magazine location is defective, or when an oversize tool requires
Magazine
Enable magazine location
Alternative
5-178
The magazine locations are listed with their tools, magazine locations
are indicated as disabled/not disabled, and the properties assigned to
the active tool (e.g. oversize) are displayed in the magazine list.
more than half a neighboring location, you can disable the magazine
location.
Operating sequence
Select with the "Magazine" softkey
Place the cursor on the relevant empty magazine location in the
"Location disable" column.
Use the "Alternative" softkey to toggle the setting until a "G"
(=disabled) appears in the field.
The location disable is now active and you can no longer assign tool
data to this magazine location.
Place the cursor on an empty magazine location in the "Location
disable" column.
Press the "Alternative" softkey until the letter "G" no longer appears.
The magazine location is enabled again.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved