Displaying Loadable Compile Cycles - Siemens SINUMERIK 840D Operator's Manual

8
03.04

8.3.7 Displaying loadable compile cycles

Service
displays
Compile
Version
cycles
Properties
Version display
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Function
If compile cycles are available in the NCK, you can display them in a
separate version display. Besides the current version (name,
extension, type, date, time, length) and the start address (path/NC-
card), the access authorization for "reading, writing, enabling, listing
and deleting" are displayed.
Loadable compile cycles are available for the following software
versions:
•
NCK SW 6.3 and higher
•
HMI Embedded: (SW 6.5 and higher)
Operating sequence
Compile cycles are loaded when you initiate an NCU reset and can be
displayed.
When you open the "Version" window in the "Service displays" menu,
the "Compile cycles" softkey is displayed.
All loaded files of the type .elf are displayed in the "Version data
compile cycles" overview.
In the "Services" operating area, you can output data via RS-232 C in
the "Manage data" basic screen. Additional storage places, such as
logical drives, are also possible.
Press the "Properties" softkey
The horizontal and vertical softkey menu changes and a "Properties"
window, such as the one below for NC card, appears.
Features
Path
:\NC-Card\Loadable-Compile-Cycles
Name
:CCMCSC
Extension
:ELF
Type
:Loadable compile cycle
Access authorization
Reading:
Contents: Loadable compile cycle
Version: MCSC Coupling axes MCS
Advance version of compile cycle (Preliminary)
Interface: 001.001@Interfaces=002.000 @TChain=001.000
Current access level:
Diagnosis Operating Area
8.3 Service display
Date:
Length:
Write:
Enable: List:
Time
8
Time
Loaded:
Delete:
Date
8-289