Inserting Data From The Clipboard - Siemens SINUMERIK 840D Operator's Manual

7
Services Operating Area
7.5 Main services screen
Import of machine data
7.5.3

Inserting data from the clipboard

Clipboard
7-264
Further information
•
The control system cannot call specific data for import.
•
If you have selected the "Overwrite and confirm" option, existing
files are overwritten after your confirmation. On rejection,
reading in continues with the next file.
•
Only data that have an extension known to the system can be
read in.
•
When importing with the setting "Without file end character" or
"Without timeout," transmission must be stopped with the STOP
softkey.
•
Transmission is not complete until the window "RS-232-C
running" is closed.
•
If a program is overwritten when data are read in, the NC
deletes the program at the beginning of the transmission
operation and inserts the program again when all data have
been transferred.
The BOOT files/INITIAL.INI initialization file produce the basic
setting of the machine.
•
The "Path from workpiece/archive" box must be checked for the
RS-232 interface before the Start command is given.
This applies both to data in archive format and in punched tape
format.
•
An "NC Reset" must then be carried out to make the machine
data operative.
Function
You can store data from the clipboard in a new directory, copy or
delete them.
Operating sequence
Data have been read into the "Clipboard" directory via the "Data in"
interface.
Select softkey "Clipboard".
The vertical softkey bar changes.
The cursor is positioned on a file in the "Clipboard" window. The
selected window is active.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
7
03.04
 Siemens AG, 2004. All rights reserved