Siemens SINUMERIK 840D Operator's Manual page 260

7
Services Operating Area
7.5 Main services screen
Set
Start
Stop
RS 232 C
user
RS 232 C
printer
RS 232 C
PG/PC
NC card
additional
7-260
The interface parameters of the currently selected interface can be
changed.
Vertical softkeys
Data read-out is started.
The data output operation is aborted.
You can select the RS-232 interface via
•
RS-232-C user
•
RS-232-C printer
•
RS-232-C PG/PC
•
is selected.
Data can be created, imported or deleted on the NC card.
If the "logical drives" option is set up, the softkeys are displayed (max
of 4 drive connections) via the softkey "additional".
The following applies in the "Services" operating area:
•
Changes resulting from data transmissions are accepted and
stored. Any modifications are thus retained when the NC powers
up again.
•
The selected window is closed. The next data tree display is
displayed in the selected view.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
7
03.04
 Siemens AG, 2004. All rights reserved