Siemens SINUMERIK 840D Operator's Manual page 58

2
Operator Components/Operating Sequences
2.5 General operating sequences
New
Support
contour
Accept
contour
Drilling Milling
Turning
OK
References
Simulation
2-58
Horizontal softkeys
Free contour programming
You can call the free control programming function via softkeys
"Support" and "New contour".
The part program block is inserted in the part program with the
appropriate parameters.
Cycle parameterization
The following programming support functions are available:
•
Drilling, milling, turning (cycles)
•
Contouring (free contour programming)
You can call up the relevant cycle compilation via the vertical softkeys
Drilling, Milling, Turning.
The part program block is inserted in the part program with the
appropriate parameters.
Example:
CYCLE81 (110, 100, 2, 35)
/PGZ/Programming Guide Cycles
Simulation
The simulation function is called.
Pressing the Cycle Start key starts the graphics simulation.
See Chapter 6: Section on "Program Simulation"
Cycle recompilation
If program steps (cycle/contour) have already been parameterized but
must be changed, you can display and edit the parameter values with
their meanings.
Position the cursor in the text editor on the line with the program step
(contour/cycle) whose parameters you wish to change.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
2
03.04
 Siemens AG, 2004. All rights reserved