Siemens SINUMERIK 840D Operator's Manual page 258

7
Services Operating Area
7.4 RS-232 C interface parameters
Parameters for DIN
programs
Punched tape input/
output
References
Reading in binary data
(FDD, MSD)
7-258
Default: RS-232-C user
Interface COM 1
Device type RTS-CTS
Baud rate 9600
Stop bits 1
Parity None X
Data bits 8
XON 11
XOFF 13
Transmission 1A
end
With this setting, programs are read in conforming to DIN (beginning
with %).
The "with leader and trailer" checkbox must be activated for tape
readers and punches.
If the punched tape reader is controlled by CTS, the "Stop with end of
transmission character" checkbox must also be activated.
Device type RTS-CTS
Baud rate 9600
Stop bits 2
Parity None X
Data bits 8
XON 00
XOFF 00 X
Transmission 00
end
/FB1/K4/ Description of Functions, Basic Machine: Communication
Device type RTS-CTS
Baud rate 9600
Stop bits 1
Parity None
Data bits 8
XON
XOFF
Transmission 00
end
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Selection of interface:
COM 1 or COM 2
Start with XON
Program start with LF
X Block end with CR LF
Stop with end of transmission
end character
X Evaluate DSR signal
Leader and trailer
X Punch tape format
Cycle watchdog
Start with XON
Program start with LF
Block end with CR LF
Stop with end of transmission
end character
X Evaluate DSR signal
Leader and trailer
Punch tape format
X Cycle watchdog
Start with XON
Program start with LF
Block end with CR LF
Stop with end of transmission
end character
Evaluate DSR signal
Leader and trailer
Punch tape format
Cycle watchdog
 Siemens AG, 2004. All rights reserved
7
03.04