Siemens SINUMERIK 840D Operator's Manual page 132

5
Parameters Operating Area
5.2 Tool offset
Tool
offset
R variables
Setting
data
Work
offset
User
data
Determine
compensa.
T No.
+
T No.
–
D No.
+
D No.
–
Delete...
Go to
Overview
New
5-132
Horizontal softkeys
You can select different data types with the horizontal softkeys:
Selection of "Tool offset" menu
Selection of "R variables" menu
Selection of "Setting data" menu
Selection of "Work offset" menu
Selection of "User data" menu
Support in determining tool offsets. This softkey is not required if the
tool management function is available.
Vertical softkeys
The vertical softkeys support data input:
Selection of the next tool
Selection of the previous tool
Selection of next higher offset number (cutting edge)
Selection of next lower offset number (cutting edge)
Deletion of a tool or cutting edge
Find any tool or the active tool
List of all available tools
New cutting edge or a new tool
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved