Function Scope - Siemens SINUMERIK 840D Operator's Manual

5
03.04
References

5.5.1 Function Scope

Tool types
Tool parameters
Magazine parameters
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5.5 Tool management ShopTurn
/BAT/ Operator's Guide ShopTurn/Tool Management
/FBW/ Description of Functions Tool Management or
/FBT/ Description of Functions ShopTurn
Function
ShopTurn tool management supports the following tool types, tool
parameters and magazine parameters:
You can create up to 250 tools under PCU 20.
You can create up to 98 replacement tools for each tool.
– Roughing tool
– Finishing tool
– Recessing tool
– Milling tool
– Drill
– Button
Limit stop
–
Threading tool
–
Rotary drill
–
3D_probe
–
– Magazine location/magazine number
– Tool type
– Tool name
– Duplo number
– Tool length compensation in the X direction
– Tool length compensation in the Z direction
– Wear radius
– Tip length of a cutting tool or a grooving cutter
– Tip width of a grooving tool
– Angle of teeth for a milling cutter
– Angle of tool tip on a drill
– Type of tool monitoring: optionally according to tool life or tool
change in relation cutting edge.
Tool state: Tool disabled
–
Tool state: Tool oversized (right and left half locations)
–
Magazine location disabled
–
Parameters Operating Area
5
5-167