Change Language - Siemens SINUMERIK 840D Operator's Manual

9
Start-Up Operating Area

9.7 Change language

References
9.7

Change language

Change
Language
Languages
OK
References
Language
Selection
9-306
The procedure used to set up the additional softkeys has already
been described.
/IAM/IM2, Installation Guide HMI Embedded, Chapter 3 "Network
Configuration Data, Connections: Logical Drives"
Function
In principle, you can use two languages in parallel.
German, English, French, Italian and Spanish are available as
standard. You can install even more languages via an additional
Language CD.
The language switch is done with the "Change Language" softkey.
However, if you want to change the two languages, proceed as
follows:
Operating sequence
Change the language default
With more than two installed languages, you can change the
language setting via the "Languages" softkey (the standard languages
are English, Spanish, French, and Italian).
Choose the two languages you require with the cursor key.
Confirm your choice with the "Select" selection key.
Confirm with "OK".
For installation and configuration of languages, see:
IAM/IM2, Chapter:. Software Installation/Upgrade
If you are using more than two languages, you can select the desired
language by pressing the "Language Selection" softkey.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
9
03.04
 Siemens AG, 2004. All rights reserved