Operator Panel Keys - Siemens SINUMERIK 840D Operator's Manual

2
03.04
OP 015A Operator Panel
A Display
B Alpha pad
C Numeric pad
1 Status LED: Power
2 Status LED: TEMP*)
3 Softkeys and direct keys
4 Front USB interface
5 Recall
6 Machine area
7 Softkeys
8 Area switchover key
9 ETC key
10 Mouse
11 Cursor pad
12 Control keypad
*) Wear will
probably be high
when the TEMP
LED is lit.
References

2.1.1 Operator panel keys

 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Notice
If a high contrast picture is displayed on the TFT display for more than
an hour, there is a danger of irreversible display damage due to the
so-called "burn-in effect".
In order to avoid this undesired effect, the screen saver must always
be active.
/IAM/IM2, Installation Guide HMI Embedded, Chapter 5 Switching on
Display Darkening Switch
The elements of the operator panel keyboard and the symbols used to
represent them in this manual are shown and explained below.
The keys marked with an * correspond to the key symbols in US
layout.
MACHINE
Direct branch to the "Machine" operating area.
Recall key
Return to the next higher menu. Recall closes a window.
Operator Components/Operating Sequences
2.1 Operator panels
2
2-29