Siemens SINUMERIK 840D Operator's Manual page 47

2
03.04
9 Program control
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
31 Stop: Channel not ready
32 Stop: Oscillation active
33 Stop: Axis replacement active (block change inhibited
because axis replacement in progress)
34 Waiting for axis container rotation
35 Wait: AXCT axis active as slave axis
36 Wait: AXCT axis active as master axis
37 Wait: AXCT axis changing to follow-up
38 Wait: AXCT internal status change in axis
39 Wait: AXCT axis drive disable
40 Wait: AXCT axis overlaid motion active
41 Wait: AXCT axis, axis replacement active
42 Wait: AXCT axis interpolator active
43 WAIT_FOR_CC_ENABLE: Waiting for compile cycle
44 Waiting for access to system variable
45 Stop; Serupro has found search target and the NCK has
stopped.
ERUPRO is the abbreviation for SEarchRUn by
PROgramtest; it is a new type of block search. SERUPRO is
activated via PI service "_N_FINDBL" parameter == 5;
SW $[[SW410000]] and later.
46 = Stop; ESR activated
47 Wait: Axis container rotation waiting for spindle stop
48 Wait: Axis container rotation waiting for MD data match (New-
Config)
49 Waiting for axis replacement: Axis currently coupled
50 Waiting for axis replacement: Liftfast active
51 Waiting for axis replacement: New-Config active
52 Waiting for axis replacement: Axis container rotation active
53 Waiting for axis replacement: Waitp active
54 Waiting for axis replacement: Axis is currently in another
channel
55 Waiting for axis replacement: Axis is currently PLC axis
56 Waiting for axis replacement: Axis is currently reciprocating
57 axis
58 Waiting for axis replacement: Axis is currently jog axis
59 Waiting for axis replacement: Axis is currently command axis
60 Waiting for axis replacement: Axis is currently OEM axis
Waiting for axis replacement: Axis is currently slave axis in
master-value coupling
61 Waiting for axis replacement: Axis is currently coupled-motion
axis
62 Waiting for axis replacement: Axis is currently coupled slave
axis
Functions that have been activated are displayed (settable via
"Program control").
Operator Components/Operating Sequences
2.4 Screen layout
2
2-47