Jog Data - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.7 Setting data

5.7.2 Jog data

G function
Jogfeedrate
Jogcontinuous
Variable increment
Jog spindle speed
Spindle
Setting
data

Jog data

5-182
Function
The feedrates must be specified in the unit determined by the G
function.
G94 Feedrate in mm (inch)/min
G95 Rotational feedrate in mm (inch)/rev
Feedrate value in Jog mode
•
Jog mode: Axis moves as long as key is pressed.
•
Continuous mode: Axis moves after pressing key once,
until
- the key is pressed again,
- NC Stop,
- Reset,
- SW/HW limit switches.
Increment value for Jog variable increment
The following data are displayed only if a spindle is configured:
Spindle speed in Jog mode
Jog data for the master spindle:
•
Spindle no.
•
Direction of rotation:
•
Spindle speed:
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Select softkey "Jog data".
The "Jog data" window is opened.
Change jog data:
Position the cursor bar on the appropriate input field and enter a new
value or
Select a new value using the "Select" key.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Name of master spindle
Direction of rotation of master spindle
Speed of the master spindle in Jog
mode
 Siemens AG, 2004. All rights reserved
5
03.04