Global Machine Status Display - Siemens SINUMERIK 840D Operator's Manual

2
03.04

2.4.2 Global machine status display

1 Operating areas
2 Channel status
3 Program status
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
11. Working windows, NC displays
The working windows (program editor) and NC displays
(feedrate, tool) available in the selected operating area are
displayed here.
From SW 6.2
Positional data in the working windows show the diameter
symbol ∅ before the unit if the axis is currently the traverse
axis and if the tool coordinate system is set. If diameter
programming is disabled with DIAMOF, the symbol preceding
the unit is no longer visible.
12. Dialog line with operator notes. Operator notes for the
selected function appear here (if available)
13. Active window
The selected window is displayed by its own frame. The
window header display is inverted. Data entered on the
operator panel front apply to this window.
14. Horizontal softkeys
15. Vertical softkeys
The softkey functions available in the selected operating area
are displayed in the horizontal and vertical softkey menus
(corresponding to F1 to F8 on the full keyboard).
The currently selected operating area is displayed (Machine,
Parameters, Program, Services, Diagnosis, Start-Up).
The current channel status is displayed,
•
Channel reset
•
Channel interrupted
•
Channel active
The current status of the running part program is
output:
•
Program aborted
•
Program running
•
Program stopped
Operator Components/Operating Sequences
2.4 Screen layout
2
2-45