Tool Offsets With D-Numbers Only (Flat D No.) - Siemens SINUMERIK 840D Operator's Manual

5
03.04

5.2.11 Tool offsets with D-numbers only (flat D no.)

Machine manufacturer
References
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
If "Jog" mode is selected, it is also possible to change the position by
traversing the axes.
The control automatically calculates the value from the reference
value and the new position.
Function
It is possible to specify that tools with a flat D number can only be
selected via their flat D number. One D number can be assigned only
once per tool, i.e. each D number represents exactly one offset data
record.
Please note information supplied by machine tool manufacturer!
/FB1/W1: Tool offset
Parameters Operating Area
5.2 Tool offset
5
5-139