Philips LPC2119 User Manual page 201

Philips Semiconductors
ARM-based Microcontroller
Table 168: PWM Match Control Register (PWMMCR - 0xE0014014)
PWMMCR Function
17 Stop on PWMMR5
18 Interrupt on PWMMR6
19 Reset on PWMMR6
20 Stop on PWMMR6
PWM Control Register (PWMPCR - 0xE001404C)
The PWM Control Register is used to enable and select the type of each PWM channel. The function of each of the bits are shown
in Table 169.
Table 169: PWM Control Register (PWMPCR - 0xE001404C)
PWMPCR Function
1:0 Reserved
2 PWMSEL2
3 PWMSEL3
4 PWMSEL4
5 PWMSEL5
6 PWMSEL6
8:7 Reserved
9 PWMENA1
10 PWMENA2
11 PWMENA3
12 PWMENA4
13 PWMENA5
14 PWMENA6
15 Reserved
Pulse Width Modulator (PWM)
When one, the PWMTC and PWMPC will be stopped and PWMTCR[0] will be set to
0 if PWMMR5 matches the PWMTC. When zero this feature is disabled
When one, an interrupt is generated when PWMMR6 matches the value in the
PWMTC. When zero this interrupt is disabled.
When one, the PWMTC will be reset if PWMMR6 matches it. When zero this feature
is disabled.
When one, the PWMTC and PWMPC will be stopped and PWMTCR[0] will be set to
0 if PWMMR6 matches the PWMTC. When zero this feature is disabled
Reserved, user software should not write ones to reserved bits. The value read from
a reserved bit is not defined.
When zero, selects single edge controlled mode for PWM2. When one, selects double
edge controlled mode for the PWM2 output.
When zero, selects single edge controlled mode for PWM3. When one, selects double
edge controlled mode for the PWM3 output.
When zero, selects single edge controlled mode for PWM4. When one, selects double
edge controlled mode for the PWM4 output.
When zero, selects single edge controlled mode for PWM5. When one, selects double
edge controlled mode for the PWM5 output.
When zero, selects single edge controlled mode for PWM6. When one, selects double
edge controlled mode for the PWM6 output.
Reserved, user software should not write ones to reserved bits. The value read from
a reserved bit is not defined.
When one, enables the PWM1 output. When zero, disables the PWM1 output.
When one, enables the PWM2 output. When zero, disables the PWM2 output.
When one, enables the PWM3 output. When zero, disables the PWM3 output.
When one, enables the PWM4 output. When zero, disables the PWM4 output.
When one, enables the PWM5 output. When zero, disables the PWM5 output.
When one, enables the PWM6 output. When zero, disables the PWM6 output.
Reserved, user software should not write ones to reserved bits. The value read from
a reserved bit is not defined.
LPC2119/2129/2292/2294
Description
Description
201
Preliminary User Manual
Reset
Value
0
0
0
0
Reset
Value
NA
0
0
0
0
0
NA
0
0
0
0
0
0
NA
January 08, 2004