Hitachi Compute Blade 500 Series User Manual page 235

To limit the IPv6 addresses from which HTTP connections are
permitted, specify the prefix length that indicates the range of IPv6
addresses to be permitted.
If you do not want to limit the addresses from which connections are
permitted, specify "0".
-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[To set the HTTP port number to 80, permit HTTP connections from IPv4
addresses between 192.168.0.0 and 192.168.0.255, and to leave HTTP
connection permission settings for IPv6 addresses unchanged]
$ set remote-access protocol http -p 80 -a allow -n
192.168.0.0 -s
255.255.255.0
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To permit HTTP connections from IPv6 addresses between fe80:: and
fe80::ffff:ffff:ffff:ffff, and to leave HTTP connection permission settings for
IPv4 addresses unchanged]
$ set remote-access protocol http -a6 allow -n6 fe80:: -p6 64
-F
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To prohibit all HTTP connections from IPv4 addresses, and to leave HTTP
connection permission settings for IPv6 addresses unchanged]
$ set remote-access protocol http -a deny
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-217