Show Remote-Access Protocol Https - Hitachi Compute Blade 500 Series User Manual

$
[To prohibit all HTTP connections from all IPv4 and IPv6 addresses]
$ set remote-access protocol http -a deny -a6 deny
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

show remote-access protocol https

Command
show remote-access protocol https
Description
Shows the setting of connection allowance of https.
This function is used to display the following items:
(1) Port number for HTTPS connections
(2) Connection permission settings for IPv4 addresses
¢
¢
(3) Connection permission settings for IPv6 addresses
¢
¢
Role
Chassis
Parameters
None
Show items
-- HTTPS setting --
2-218
Whether HTTPS connections are permitted
Range of IP addresses to be permitted (network address and subnet
mask)
Whether HTTPS connections are permitted
Range of IP addresses to be permitted (network address and prefix
length)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide