Show Wwn Original - Hitachi Compute Blade 500 Series User Manual

E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP.

show wwn original

Command
Show wwn original [-b <blade_no>] [-p]
Description
Displays Default Physical WWN which the card installed on server blade is
using.
In SMP configuration
When you specify the primary server blade or a non-primary server blade,
WWN of the specified server blade is displayed.
When specifying -p parameter, specify the primary server blade with -b
parameter to show WWNs of all server blades in SMP configuration.
Not in SMP configuration
Shows WWN of the server blade specified with -b parameter. Even if -p
parameter is specified, the result is the same.
Role
Chassis
Parameters
-b <blade_no>
Slot number of the server blade in the server chassis
-p
In SMP configuration, when you specify -p parameter, WWNs of all server
blades are shown. Then, specify the primary server blade. Not in SMP
configuration, WWN of each server blade is shown.
Show items
-- Original WWN List--
Slot
2-12
Command: show wwn original -b <server blade number>
Command: show wwn original -b <server blade number> -p
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted,
the command shows all server blades.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide