Init Blade Bmc Setting - Hitachi Compute Blade 500 Series User Manual

Parameters
<blade_no>
Slot number of server blade in the server chassis
-F
Show items
None
Message
None
Example
[Disconnects all Remote Console session of BMC in the server blade 0.]
$ disconnect blade bmc session 0
Confirm? (y/[n]):y
I0047 : <Blade 0> Disconnect was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
When you specify a non-primary server blade in SMP configuration, the
following message appears without disconnecting the session.
E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP.

init blade bmc setting

Command
init blade bmc setting [<blade_no>] [-F]
Description
Initializes the setting of BMC on the server blade.
Initializes BMC setting information on a specified server blade regardless of
whether the server blade is in SMP configuration or not.
Range is from 0 to 7.
Only one server blade can be selected.
Executes the command without inquiry.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-41