Assign Blade Hvm Firmware - Hitachi Compute Blade 500 Series User Manual

-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[Enable Performance tuning options for server blade 0]
$ set blade hvm setting 0 -pt enable -F
I0037 : <Blade 0> Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None

assign blade hvm firmware

Command
assign blade hvm firmware <blade_no> {-b <hvm_bank_no>|-d} [-F]
Description
Assigns the LP firmware to server blade.
In SMP configuration, when you specify the primary server blade, LP firmware
used for all server blades in the configuration is assigned to the primary
server blade. When you specify a non-primary server blade, LP firmware is
assigned to the server blade but not affect the operation. The following
message appears, noticing that the LP firmware assignment cannot affect the
operation.
W0031 : <Blade X> Set data is not used. Specified blade is not the primary
blade of SMP. (X: the specified server blade number)
Role
Server Blade
2-50
enable: Enabled
disable: Disabled
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide