Reset Blade - Hitachi Compute Blade 500 Series User Manual

I0033 : <Blade 6> Restart was completed.
I0033 : <Blade 7> Restart was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
If you do not restart BMC simultaneously on all server blades in SMP
configuration, initialization may fail. When you specify -sb parameter and not
specify all server blades in SMP configuration, the following message appears,
noticing that initialization may fail.
W0032 : <Blade X> A part of the blades of the SMP is specified. Initialize
may not complete. (X: a specified server blade number)
When you specify -h or -s parameter and a non-primary server blade in SMP
configuration, the following message appears without turning OFF and ON the
sub power supply or restarting BMC.
E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP.

reset blade

Command
reset blade [<blade_no>] [-h|-s] [-F]
Description
Resets the server blade using the following two methods.
• Hard reset
• NMI issue
You can select one of methods above by specifying a parameter, -h or -s.
• Hard reset
Specify -h to execute hard reset on the server blade.
• NMI issue
Specify -s to send NMI (Non-Maskable Interrupt) to the OS running on
the server blade.
When neither -h nor -s is specified, hard reset will be executed in the same
way as -h is specified.
In SMP configuration, specify the primary server blade to reset all server
blades in the configuration.
Role
Server Blade
2-58
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide