Hitachi Compute Blade 500 Series User Manual page 240

-p6 <prefix_len>
Prefix length
-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[To set the HTTPS port number to 443, to permit HTTPS connections from
IPv4 addresses between 192.168.0.0 and 192.168.0.255, and to leave the
HTTPS connection permission settings for IPv6 addresses unchanged]
$ set remote-access protocol https -p 443 -a allow -n
192.168.0.0 -s 255.255.255.0 -F
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[To permit HTTPS connections from IPv6 addresses between fe80:: and
fe80::ffff:ffff:ffff:ffff, and to leave the HTTPS connection permission settings
for IPv4 addresses unchanged]
$ set remote-access protocol https -a6 allow -n6 fe80:: -p6 64
-F
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
2-222
To limit the IPv6 addresses from which HTTP connections are
permitted, specify the network address that indicates the range of
IPv6 addresses to be permitted.
If you do not want to limit the addresses from which connections are
permitted, specify "::".
To limit the IPv6 addresses from which HTTP connections are
permitted, specify the prefix length that indicates the range of IPv6
addresses to be permitted.
If you do not want to limit the addresses from which connections are
permitted, specify "0".
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide