Hitachi Compute Blade 500 Series User Manual page 239

Whether HTTPS connections are permitted
¢
Range of IP addresses to be permitted (network address and prefix
¢
length)
If you omit a parameter, the corresponding settings will not be changed. If
you omit all parameters, the command will end normally without making any
changes.
Role
Chassis
Parameters
-a <allow>
IPv4 connection permission
allow: Permits IPv4 connections.
deny: Prohibits IPv4 connections.
-p <protocol_port>
Port number of protocol.
Range is from 1 to 65535.
-n <network_addr>
Network address
To limit the IPv4 addresses from which HTTP connections are
permitted, specify the network address that indicates the range of
IPv4 addresses to be permitted.
If you do not want to limit the addresses from which connections are
permitted, specify "0.0.0.0".
-s <subnet_mask>
Subnet mask
To limit the IPv4 addresses from which HTTP connections are
permitted, specify the subnet mask that indicates the range of IPv4
addresses to be permitted.
If you do not want to limit the addresses from which connections are
permitted, specify "0.0.0.0".
-a6 <allow>
IPv6 connection permission
allow: Permits IPv6 connections.
deny: Prohibits IPv6 connections.
-n6 <network_addr>
Network address
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-221