Notes About Acknowledgment (Configuration) - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.4 Project folder
Table 4-10
Button
Output
Alarms
Log...
Back / Next
Cancel
4.4.2.6

Notes about acknowledgment (configuration)

You can configure the following property groups for the "Notes about acknowledgment" dialog
page:
● Dialog
● Operating instructions
126
Meaning of buttons
Meaning
The output window is shown or hidden. Status messages are displayed in
the output window while the package is being executed.
The alarm list is shown or hidden. It displays errors and messages from NC,
PLC, drive, and HMI.
It approximately corresponds to the "Diagnostics" used in SINUMERIK Op‐
erate.
This button opens the CMC logbook for package execution.
These buttons lead you through the dialog pages.
The execution of the package is canceled. A confirmation prompt is always
displayed, which must be acknowledged. After a dialog is canceled, the "Fin‐
ish" dialog is always displayed, thus allowing the logbook to be backed up.
The cancellation process can take place immediately or after a time delay,
depending on the dialog page and the execution status.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD