User-specified topology
This dialog version is used for the SINAMICS topology if "User-specified topology" was
selected for the device configuration for the drives.
Figure 4-35
Performing axis-drive assignment
Setting the check mark activates automatic axis-drive assignment.
As a prerequisite, this Axis-drive assignment must have been configured and activated in Topo.
DRIVE-CLiQ wiring
The Drive-CLiQ wiring of the components, the activation state, the assignments of the DO
variables and additional properties are displayed in the center of the dialog page.
The three different activation states of the SINAMICS elements are:
● "0" for deactivated
● "1" for activated
● "2" for not available
The activation states in columns "K" (Component) and "DO" (Drive Object) can be interactively
adapted. With a click on the relevant cell, the three states are connected. The keyboard can
be operated with up/down and letters "K" and "D".
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
SINAMICS topology - commissioning engineer/operator view - example for user-specified
topology
Create MyConfig - Expert
4.4 Project folder
177