Siemens SINUMERIK 840D sl Operating Manual page 172

Create MyConfig - Expert
4.4 Project folder
The following properties are available for the "comparison topology (*.ust)", which are activated
when the package is executed:
List
Preselection
User-specified topology (*.utz)
Note
Prerequisite for user-specified topology
If, on the "System configuration" dialog page, User-specified topology has been selected under
"DRV archive data/drive configuration > Data source", a configured user-specified topology
always applies.
If no critical inconsistency with the real topology is found by the drive in the user-defined
topology, the user-defined topology is applied as the target topology by SINAMICS.
The following properties are available for the "user-specified topology (*.utz)", which are
activated when the package is executed:
List
Preselection
Note
The "SINAMICS topology" dialog differs during package execution depending on whether the
drive configuration "User-specified topology" or one of the three other variants has been
selected in the "System configuration" dialog.
172
The button opens the "List of topologies (*.ust)" dialog.
Select the desired topology from the list.
Comparison topologies can be pasted or inserted as link under "List".
These are also saved in the package during deployment and can be selected
during package execution.
Select a topology that is to be preselected for the package execution.
Alternatively, enter the path of a file which is located next to the package "/
<Path>/<File>", e.g. "Comparison topology.ust".
The button opens the "List of user-specified topologies (*.utz)" dialog.
Select the desired User-specified topology (*.utz) from the list.
User-specified topologies can be pasted or inserted as link under "List".
These are also saved in the package during deployment and can be selected
during package execution.
Select a user-specified topology (*.utz) that is to be preselected for the
package execution.
Alternatively, enter the path of a file which is located next to the package "/
<Path>/<File>", e.g. "user-defined topology.utz".
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD