Siemens SINUMERIK 840D sl Operating Manual page 178

Create MyConfig - Expert
4.4 Project folder
The "SM" column indicates as to whether a sensor module involves a first or second encoder.
Sensor modules are displayed in blue.
Column "AX DR" includes information about theaxis-drive assignment.
User-specified topology(*.utz)
Using the "User-specified topology" drop-down list, a file that was assigned to the package or
a file located next to the package (prefix: "./") can be used.
A file from a different location can be selected with the "Browse" button. You cannot move
forward in the dialog without selecting a valid *.utz file.
Manual DO variable assignment
This dialog version is used for the SINAMICS topology if "Initial state", "Offline archive" or
"Automatic configuration" was selected and no comparison topology was selected for the
device configuration for drives.
In this case, automatic axis-drive assignment is not possible using the dialog, as no
Comparison topology (*.ust) and no User-specified topology (*.utz) are available in which the
required axis-drive assignment is possibly configured.
The following diagram is an example of the dialog page when not using a comparison topology,
after automatic device configuration.
Figure 4-36
178
SINAMICS topology - commissioning engineer/operator view - example for manual DO
variable assignment
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD