Siemens SINUMERIK 840D sl Operating Manual page 39

Example 2: Copying NC axis machine data
For the selection shown, the following content is obtained for the clipboard or file:
CHANDATA(1)
N32000 $MA_MAX_AX_VELO[AX6]=8000
N32010 $MA_JOG_VELO_RAPID[AX6]=8000
N32020 $MA_JOG_VELO[AX6]=550
N32060 $MA_POS_AX_VELO[AX6]=8000
The identifiers extracted by Diff are fully qualified, i.e. they again include the definition of the
axis to which the data belongs.
Note
CHANDATA(1) is also automatically added for channel-independent data as this guarantees
that a previous channel assignment greater than 1 is reset again.
Channel-independent data must not be located below a CHANDATA operation greater than
1.
Copy/export format "Value table"
For the copy/export format "Value table", data is extracted in tabular form. This means that all
selected identifiers are saved in the first column, and in the additional columns, the value of
the particular comparison object (archive, file or node).
To copy or export data in this form, the identifiers in the Identifier column must be selected, as
shown in the following example.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Create MyConfig - Diff
3.3 SINUMERIK archive comparison
39