Ncu/Ppu Initial State (Configuration) - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.4 Project folder
If, in the Package tab, under "Data areas > Use NCU/PPU" has been selected, this dialog page
is executed automatically when executing a package.
You will find additional information on package execution in the section under Package
execution (Page 317).
Figure 4-20
Buttons for the package processing dialogs
Information on the general buttons in the dialogs can be found under Meaning of buttons
(Page 126).
4.4.2.16

NCU/PPU initial state (configuration)

You can configure the following property groups for the "NCU/PPU initial state" dialog page:
● Dialog
● Operating instructions
● Data backup CF card
● Archive
● Dialog scripts
142
NCU/PPU access - commissioning engineer / operator view
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD