Figure 4-29
By selecting the data areas in the Package tab, the usable dialog pages are defined in the
Dialog tab.
You can find an overview for this in the section Dependencies of the dialog pages of data
areas (Page 114).
Overview of System configuration dialog
The source or output data is provided via the "System configuration" dialog page.
This data is then manipulated later on the "SINAMICS topology" and "Step tree" dialog pages.
At the end of execution of the "Step tree" dialog page, the changed data is transferred to the
control or the result archive.
On the "System configuration" dialog page, you can define for every archive area (NC, PLC,
DRV) whether it should be used.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
System configuration - project engineer view
Create MyConfig - Expert
4.4 Project folder
159