Siemens SINUMERIK 840D sl Operating Manual page 233

Figure 4-64 Example 2 - deleting tool data from the INITIAL.INI
In the configuration file for the SED editor, additional script-controlled operations could be
inserted depending on Up variables or Config variables.
Figure 4-65 Example 2 - inserting script-controlled operations
Target areas
Note
Selected data areas define target areas
Which target areas are displayed depends on the data areas (archive, PCU, NCU) that were
activated for use.
The data areas are defined in the project folder in the Package tab (Page 106).
If a data area is subsequently deactivated, then all of the target area nodes that cannot be
hidden due to content are shown in red.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Create MyConfig - Expert
4.5 Component editor
233