Siemens SINAMICS G130 Operating Instructions Manual page 196

Converter built-in units 75 kw-800 kw

Hide thumbs Also See for SINAMICS G130:

Table of Contents

6.3 Basic information about the drive system

Copying the command data set (CDS)

Set parameter p0809 as follows:

1. p0809[0] = number of the command data set to be copied (source)

2. p0809[1] = number of the command data to which the data is to be copied (target)

3. p0809[2] = 1

Start copying.

Copying is finished when p0809[2] = 0.

Copying the drive data set (DDS)

Set parameter p0819 as follows:

1. p0819[0] = Number of the drive data set to be copied (source)

2. p0819[1] = Number of the drive data set to which the data is to be copied (target)

3. p0819[2] = 1

Start copying.

Copying is finished when p0819[2] = 0.

Copy motor data set (MDS)

Set parameter p0139 as follows:

1. p0139[0] = Number of the motor data set that is to be copied (source)

2. p0139[1] = Number of the motor data set which should be copied into (target)

3. p0139[2] = 1

Start copying.

Copying has been completed, if p0139[2] = 0.

Function diagram

Command data sets (CDS)

Drive data set (DDS)

Encoder data set (EDS)

Motor data sets (MDS)

Inverter chassis units

Operating Instructions, 07/2016, A5E00331449A