Siemens SINAMICS G130 Operating Instructions Manual page 209

Converter built-in units 75 kw-800 kw

Hide thumbs Also See for SINAMICS G130:

Table of Contents

Terminal assignment, Control Unit with "CU terminals" default setting

When you choose the "CU terminals" default setting, use the following terminal assignment

for the Control Unit:

Changing over the command source

If necessary, the command source can be changed over using the LOCAL/REMOTE key on

Inverter chassis units

Operating Instructions, 07/2016, A5E00331449A

Terminal assignment, Control Unit with "CU terminals" default setting

6.4 Command sources