Replacing A Vcn500 - Huawei FusionModule 1000A40 Maintenance Manual

Hide thumbs Also See for FusionModule 1000A40:

Table of Contents

FusionModule1000A40 IT Solution

Maintenance Guide (2016.05, AI Version)

Step 3 Remove the network cable and take out the camera.

Step 4 Install a new camera, secure the camera base, and reconnect the network cable. For details,

see the documents delivered with the camera.

Step 5 Configure the camera by referring to the management system initial configuration table.

Step 6 Adjust the camera angle to cover the area to be monitored. For details, see the documents

delivered with the camera.

Step 7 Check that the new camera is working properly.

Step 8 Reinstall the camera cover.

----End

Follow-up Procedure

Dispose of the removed camera that is confirmed faulty.

5.3.4 Replacing a VCN500

Prerequisites



Impact on the System

The operation of the monitoring system or devices may be interrupted.

Preparations

Tools: Phillips screwdriver, small-sized flat-head screwdriver, ESD gloves, marker

Materials: spare VCN500

Document: documents delivered with the VCN500

Skill requirement: weak-current engineer

Procedure

Step 1 Make a note of the cable connection and ports of the VCN500 to be replaced using the

marker.

Step 2 Shut down the VCN500, and disconnect the power plug.

Step 3 Remove all cables from the VCN500.

Step 4 Loosen the captive screws in the mounting ears using a Phillips screwdriver, and remove the

faulty VCN500.

Issue 04 (2018-01-05)

The original parameter settings can be used.

If the red indicator of the camera is on, the camera is working properly.

A VCN500 needs to be replaced.

A spare VCN500 of the same model is available and functional.

Huawei Proprietary and Confidential

5 Components Replacement

Table of Contents