Axial Measurement (Measa, Meawa, Meac) (Option) - Siemens SINUMERIK 840D sl Programming Manual

Special motion commands

4.8 Axial measurement (MEASA, MEAWA, MEAC) (option)

4.8 Axial measurement (MEASA, MEAWA, MEAC) (option)
Function
Several probes and several measuring systems can be used for the axial measuring.
The keywords
With
each measurement and are then saved in system variables in accordance with the trigger
event.
Measuring operations can be executed with
stored in FIFO variables.
Syntax
MEASA[<axis>]=(<mode>,<TE1>,...,<TE4>)
MEAWA[<axis>]=(<mode>,<TE1>,...,<TE4>)
MEAC[<axis>]=(<mode>,<measurement memory>,<TE1>,...,<TE4>)
Note
MEASA
MEASA
output.
256
, and
MEASA MEAWE
or for the programmed axis, up to four measured values are acquired for
MEASA MEAWA
and are non-modal; they can be programmed together in one block. However, if
MEAWA
/ is programmed together with
MEAWA
are available for programming the function.
MEAC
. In this case, the measurement results are
MEAC
/ in the same block, an error message is
MEAS MEAW
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Job Planning