Siemens SINUMERIK 840D sl Programming Manual page 515

Further information
Use in synchronized actions
All commands for reading curve table values can also be used in synchronized actions (see
also the chapter titled "Motion-synchronous actions").
When using the
● Sufficient NC power is available at the time of execution
● The number of segments in the curve table is queried prior to the call, so that the table
CTAB with non-periodic curve tables
If the specified
output as the following value:
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
,
CTABINV CTABTMIN
or
concerned can be subdivided if necessary
<master value>
, and commands, make sure that:
CTABTMAX
is outside the definition range, the upper or lower limit will be
Axis couplings
11.2 Curve tables (CTAB)
515