Freely Programmable Positions - Cycle802 - Siemens SINUMERIK 840D sl Programming Manual

Programming cycles externally
18.1 Technology cycles
Note
Parameters 21, 22 and 23 are only used for thread selection in the input mask thread
1)
tables. The thread tables cannot be accessed via cycle definition in the cycle run time.
18.1.10

Freely programmable positions - CYCLE802

Programming
CYCLE802(INT _XA, INT _YA, REAL _X0, REAL _Y0, REAL _X1, REAL _Y1,
REAL _X2, REAL _Y2, REAL _X3, REAL _Y3, REAL _X4, REAL _Y4, REAL
_X5, REAL _Y5, REAL _X6, REAL _Y6, REAL _X7, REAL _Y7, REAL _X8,
REAL _Y8, INT _VARI, INT _UMODE, INT _DMODE)
Parameters
No. Param Param
mask
intern
1 _XA
_YA
2
3 X0 _X0
4 Y0 _Y0
X1 _X1
5
Y1 _Y1
6
7 X2 _X2
8 Y2 _Y2
9 X3 _X3
10 Y3 _Y3
X4 _X4
11
Y4 _Y4
12
13 X5 _X5
14 Y5 _Y5
656
Explanation
Alternatives for all X positions (9-digit decimal value)
Number of digits: 876543210 (digit position corresponds to drilling position Xn)
Position value:
1 = Absolute (1st programmed position is always absolute)
2 = Incremental
Alternatives for all Y positions (9-digit decimal value)
Number of digits: 876543210 (digit position corresponds to drilling position Yn)
Position value:
1 = Enter position (abs)
2 = Enter position (inc)
1st position X
1st position Y
2nd position X
2nd position Y
3rd position X
3rd position Y
4th position X
4th position Y
5th position X
5th position Y
6th position X
6th position Y
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Job Planning