Siemens SINUMERIK 840D sl Programming Manual page 33

Redefinition ( ) of system and user variables
REDEF
During redefinition an initialization value can be preassigned for the following variables:
● System data
● User data
Reinitialization time
During redefinition the point in time can be specified at which the variable should be
reinitialized, i.e. reset to the initialization value.
●
●
●
●
Table 1- 1
Number
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
– Setting data
– R parameters
– Synchronized action variables ($AC_MARKER, $AC_PARAM, $AC_TIMER)
– Synchronized action GUD (SYG_xy[ ], where x=R, I, B, A, C, S and y=S, M, U, 4 to 9)
– EPS parameters
– Tool data OEM
– Magazine data OEM
– Global user variables (GUD)
(POWER ON)
INIPO
The variable is reinitialized at Power On.
(reset)
INIRE
The variable is reinitialized on NC reset, mode group reset, at the end of the part program
( / ) or at Power On.
M02 M30
(NewConfig)
INICF
The variable is reinitialized on a NewConf request via the HMI, with part program
command or on an NC reset, mode group reset, at the end of the part program
NEWCONFIG
(M02/M30) or at Power On.
(program-local change)
PRLOC
The variable is only reinitialized on an NC reset, mode group reset or at the end of the
part program (M02/M30) if it has changed during the current part program.
The attribute may only be changed in conjunction with programmable setting data
PRLOC
(see the table below).
Programmable setting data
Identifier
42000 $SC_THREAD_START_ANGLE
42010 $SC_THREAD_RAMP_DISP
42400 $SA_PUNCH_DWELLTIME
42800 $SA_SPIND_ASSIGN_TAB
43210 $SA_SPIND_MIN_VELO_G25
43220 $SA_SPIND_MAX_VELO_G26
43230 $SA_SPIND_MAX_VELO_LIMS
Flexible NC programming
1.1 Variables
G command
1)
SF
/
DITS DITE
PDELAYON
SETMS
G25
G26
LIMS
33