Siemens SINUMERIK 840D sl Programming Manual page 619

POLFMASK
POLFMLIN
Note
Before rapid retraction to a fixed position can be enabled via
must have been programmed with
Note
If axes are enabled one after the other with
the last definition always applies for the particular axis.
Note
The positions programmed with
when the part program is started. This means that the user must reprogram the values for
POLF
Note
If, when using the abbreviated form
ensure that either the retraction position or the retraction path contains a practical and
sensible value. In particular, the retraction position and the retraction path have to be set
again after Power On.
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
: Predefined subprogram call for selection of the axes that are to be retracted
after tripping of rapid lift independently of one another.
:
<axis_1>,...
without specification of an axis deactivates the rapid lift for all
POLFMASK()
axes that have been retracted independently of one another.
: Predefined subprogram call for selection of the axes that are to be retracted
after tripping of rapid lift in linear relation.
:
<axis_1>,...
without specification of an axis deactivates the rapid lift for all
POLFMLIN()
axes that have been retracted in linear relation.
and the selected axes in
Names of the axes that are to be traversed to their
positions defined with
All the axes specified must be in the same coordinate
system.
See above.
for the selected axes.
POLF
,
POLFMASK
and the activation by
POLF
or in each part program.
POLFMASK POLFMLIN
only the type is changed, then the user must
POLFA
Additional functions
16.11 Extended stop and retract (ESR)
during rapid lift.
POLF
or
POLFMASK POLFMLIN
or ,
POLFMLIN POLFMLIN POLFMASK
or
POLFMASK POLFMLIN
a position
, then
are deleted
619