Milling A Rectangular Pocket - Pocket3 - Siemens SINUMERIK 840D sl Programming Manual

Programming cycles externally
18.1 Technology cycles
No. Param Param
mask internal
15 _DMODE
_AMODE
16
18.1.15

Milling a rectangular pocket - POCKET3

Programming
POCKET3(REAL _RTP, REAL _RFP, REAL _SDIS, REAL _DP, REAL _LENG, REAL
_WID, REAL _CRAD, REAL _PA, REAL _PO, REAL _STA, REAL _MID, REAL
_FAL, REAL _FALD, REAL _FFP1, REAL _FFD, INT _CDIR, INT _VARI, REAL
_MIDA, REAL _AP1, REAL _AP2, REAL _AD, REAL _RAD1, REAL _DP1, INT
_UMODE, REAL _FS, REAL _ZFS, INT _GMODE, INT _DMODE, INT _AMODE)
Parameters
No. Param Param
mask internal
RP _RTP
1
Z0 _RFP
2
662
Explanation
THOUSANDS: Limit 2nd axis positive
0 = No
1 = Yes
Display mode
UNITS: Machining plane G17/18/19
0 = Compatibility, the plane effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
UNITS: Final depth (_DP)
0 = Absolute
1 = Incremental
TENS: Unit for plane infeed (_MIDA)
0 = mm
1 = % of tool diameter
HUNDREDS: Reserved
THOUSANDS: Length of surface
0 = Incremental
1 = Absolute
TEN THOUSANDS: Width of surface
0 = Incremental
1 = Absolute
Explanation
Retraction plane (abs)
Reference point of tool axis (abs)
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Job Planning