Mitsubishi Electric MELSEC Q Series Programming Manual page 122

4 PARAMETERS FOR POSITIONING CONTROL
4. PARAMETERS FOR POSITIONING CONTROL
4.1 System Settings
In the Multiple CPU system, the common system parameters and individual
parameters are set for each CPU and written to each CPU.
(1) The base settings, Multiple CPU settings and Motion slot settings are set in the
(2) The following are set in the individual parameter setting.
(3) The data setting and correction can be performed in MT Developer2.
common system parameter setting.
• System basic setting
• SSCNET setting QDS
• CPU name setting
• Built-in Ethernet port setting
• CPU setting
• Manual pulse generator/synchronous encoder setting
• Servo amplifier setting
• High-speed read setting
• Optional data monitor setting
• Mark detection setting QDS
(Refer to the "Q173D(S)CPU/Q172D(S)CPU Motion Controller Programming
Manual (COMMON)" for details of the setting contents.)
4 - 1
QDS
4