Mitsubishi Electric MELSEC Q Series Programming Manual page 481

7 AUXILIARY AND APPLIED FUNCTIONS
(c) Current feed value during torque control mode
Feed current value (D0+20n, D1+20n) and real current value (D2+20n,
D3+20n) are updated even in torque control. If the current feed value
exceeds the software stroke limit, a minor error (error code: 207) will occur
and the operation is switched to position control mode. Invalidate the
software stroke limit to execute one-way feed.
(d) Stop cause during speed control mode
The operation for stop cause during torque control mode is shown below.
Item
The stop command (M3200+20n) turned ON.
The rapid stop command (M3201+20n)
turned ON.
The external stop input turned ON.
The All axis servo ON command (M2042)
turned OFF.
The servo OFF command (M3215+20n)
turned ON.
The current value reached to software stroke
limit.
The position of motor reached to hardware
stroke limit
The PLC ready flag (M2000) turned OFF.
The forced stop input to Motion CPU.
The forced stop input to servo amplifier.
The servo error occurred.
The servo amplifier's power supply turned
OFF.
Operation during torque control mode
The speed limit command value commanded to servo
amplifier is "0" regardless of the setting value of "Speed
command device". The mode is switched to position control
mode when "Zero speed (b3)" of servo status2 (#8011+20n)
turns ON, and the operation stops immediately.
(Deceleration processing is not executed.)
The value of command torque is not changed. It might take
time to reach at the speed "0" depending on the current
torque command value.
The servo OFF is not executed during torque control mode.
The command status at that time becomes valid when the
mode is switched to position control mode.
The minor error (error code: 200, 207) and major error
(error code: 1101, 1102) will occur. The mode is switched to
position control mode at current position, and the operation
immediately stops. (Deceleration processing is not
executed.)
The mode is switched to position control mode when the
servo OFF (The servo ready signal (M2415+20n) turns
OFF) is executed.
(While the servo amplifier is servo OFF, even if the mode is
switched to position control mode, the servo motor occurs
to the free run. (The operation stops with dynamic brake.))
The motor occurs to the free run. (The operation stops with
dynamic brake.)
(The mode is to position control mode at the servo
amplifier's power supply ON again.)
7 - 36