Mitsubishi Electric MELSEC Q Series Programming Manual page 286

6 POSITIONING CONTROL
(5) Motion SFC program
Motion SFC program for which executes the servo program is shown below.
Speed control ( )
Speed control ( )
[F10]
SET M2042
[G10]
PX000*M2455
[K55]
VVF
Axis 3
Speed 4000pulse/s
[G20]
!PX000
[F20]
SET M3240
[G30]
!M2003
[F30]
RST M3240
END
(Note): Example of the above Motion SFC program is started using the automatic start or sequence program.
Turn on all axes servo ON command.
Wait until PX000 and Axis 3 servo ready turn on.
Speed control ( ) (Forward rotation)
Axis used . . . . . . . . . Axis 3
Positioning speed . . . 4000[pulse/s]
Wait until PX000 turn off after speed control ( ) start.
Turn on Axis 3 stop command.
Wait until Axis 3 start accept flag turn off.
Turn off Axis 3 stop command.
6 - 99