Mitsubishi Electric MELSEC Q Series Programming Manual page 465

7 AUXILIARY AND APPLIED FUNCTIONS
Speed limit value at
speed-torque control
30000
20000
-10000
-20000
Speed limit value at
speed-torque control
Speed command device
(6) Command speed acceleration time, Command speed deceleration
time
Set the acceleration time for the speed to increase from "0" to reach the speed
limit value at speed-torque control and deceleration time taken to stop from the
speed limit value at speed-torque control during speed control or continuous
operation to torque control.
Command speed
acceleration time
V
0
0 20000 30000
When the rotation direction is changed due to the command speed change
during speed control, the operation is as follows.
• A deceleration is made to 0 [r/min] according to the setting value of command
speed deceleration time. After that, an acceleration is made to the command
speed according to the setting value of command speed acceleration time.
Command speed
deceleration time
The command value to the servo amplifier is stored
at the command speed (#8004+20n, #8005+20n).
Command speed
acceleration time
0 -10000
7 - 20
t
Command speed
deceleration time
-20000 0