Fujitsu Airstage J-II Series Design & Technical Manual page 649

„ INDOOR UNIT SETTING
„
Refer to the correct SW position for 2. Function Setting.
<Step 1>
Refrigerant circuit address setting
<Step 2>
Indoor unit address setting
<Step 3>
Remote controller address setting
<Step 4>
Function setting
„ RB UNIT SETTING
„
Refer to the correct SW position for 2. Function Setting.
(This function is available VR-II series.)
<Step 1>
Refrigerant circuit address setting
<Step 2>
RB unit address setting
„ REMOTE CONTROLLER SETTING
„
(Only for Wired remote controller and Simple remote controller)
Dual remote control setting
¾ Other than the unit above, refer to "2. Function setting" and the installation manual.
„
Set the Rotary SW REF AD x10 & x1.
For details, refer to "1-2. Address setting".
Set the Rotary SW IU AD x10 & x1.
For details, refer to "1-2. Address setting".
Set the Rotary SW RC AD.
For details, refer to "1-2. Address setting".
Set the Rotary SW REF AD x10 & x1.
For details, refer to "1-2. Address setting".
Set the Rotary SW RB AD x10 & x1.
For details, refer to "1-2. Address setting".
Set the SW 2 of DIP Switch 1.
For details, refer to "2. Function setting".
- (07 - 02) -